Eureka Tents Tent High Camp User Manual

H
F
ASSEMBLY INSTRUCTIONS  
FOR THE HIGH CAMP TENT  
Orange Brim  
Rod  
I
Component List:  
1 Tent Body w/attached guy ropes 1 Brim Rod 4 Tent Poles  
1 Carry Bag 1 Pole Bag 1 Bag w/ Stakes  
Fig.6  
Assembly:  
1 Unpack the carry bag and separate the  
components. Unfold the tent body and lay it out  
with the floor on the ground and a grommeted web  
in each corner. Pull the tent into a rough rectangle.  
Do not stake down the tent just yet; but in windy  
conditions, stake down one corner that faces into  
the wind.  
Fig.7  
E
Fig.3  
G
7 Stake the tent down. Your tent is now free standing.  
Place it in the desired location and stake it down with  
the aluminum skewers. See fig. 8.  
5 Clip the fabric to the tent poles.  
Working your way around the tent,  
attach those carabineers and pole  
clips that align with the poles. See  
fig.4 and 5.  
2 Assemble the shock corded Gold tent poles and  
Orange brim rod. Carefully seat  
each section. Try to keep the poles  
from snapping together as this can  
damage the ends. Divide the Gold  
poles according to size and shape.  
Set the Orange rod aside.  
8 Attach the fly to the tent.  
Fig.8  
• Spread the fly on the ground. Find the corner with reflective  
web and attach it to that corner of the tent with matching  
reflective web. Drape the fly, right side up, on top of the  
tent so that the vestibule covers the door.  
Fig.4  
• Reach under the fly and attach all the Velcro® tabs to the  
poles. See fig.9.  
3 Insert the tent poles into the web  
grommets.  
• Near each side of the door, insert  
a long Gold pole into the web  
grommet. See fig.1.  
Then arrange the poles diagonally  
across the tent from A to B and C  
• Connect the side release buckles on the fly to their mates  
on the tent.  
• Move to the rear of the tent. Use the yellow stakes to stake  
out the web loop on the back vestibule, but do not adjust  
the tension just yet. Go to the front of tent and stake out  
the two web loops on the front vestibule.  
Fig.9  
to D. See fig.2.  
Fig.1  
9 Adjust the tension on the webs. Work your way around the  
tent, tighten the web buckles until the fly/vestibule is taut.  
See fig. 10.  
Fig.5  
6 Install all remaining poles, clips and carabineers.  
• Slide a Gold pole through the two carabineers at the  
top of the door. Seat the post into the grommet on the  
side web at E. On the direct opposite side at F, grasp  
the end of the pole and push it up to form an arc.  
Insert the post into the web grommet at F and attach  
the clips.  
• Continue with the next Gold pole from G to H.  
Note: Seat the posts into the first grommet on the side  
webs. Whenever poles cross,capture both with the  
carabineers. See fig.6.  
• Slide the Orange pole through the two carabiners in  
front of the door. Seat the post into the outside  
grommet on the side web at G. On the opposite side I  
grasp the end of the pole and push it up to form an  
arc. Insert the post into the web grommet. See fig.7.  
10 Stake out the attached guy lines and adjust the sliders to  
a proper tension.  
See fig.11.  
Fig.10  
Fig.2  
Your Tent  
Is Ready  
4 Raise the tent.  
• At B, push the pole from B to A to create an arc. Insert  
the locking post into the grommet on web to maintain  
tension.  
• Repeat with the second pole from C to D.  
• Lift both poles over the center of the tent. Lift the  
center carabineer on the tent fabric and capture both  
poles with the carabineer. Make sure the carabineer is  
locked in place. See fig.3.  
Fig.11  
REV B 4.09  
 

AAMP of America Speaker TI57CX User Manual
Abit Computer Hardware AW9D User Manual
Acer Computer Monitor 501 User Manual
Acu Rite Weather Radio 01098CDI User Manual
Alto Shaam Oven 1000 TH SERIES User Manual
Alvarez Car Speaker SA1521z User Manual
Atlantis Land Switch A07 ES3526VA PoE User Manual
Atlas Sound Telephone CE Series User Manual
Ayre Acoustics Stereo Amplifier AX 7E User Manual
BK Stereo Receiver AVR101 Series User Manual